RLF01A-SAB-AA00，英国NORGREN气缸型号
VDE注册。 0110（除微动触点间隙）。
*因为它会腐烂金镀不是必需的。zui大。烫发。浪涌
电流（appr.30毫秒）ACmake=zui大。 1。
*需要镀（不会衰减）。
†临界电压的下限值可以保证足够的接触安全。
低电压有利的条件下允许的。
星火直流电压淬火（建议）
1，在平行于感性负载二极管D。
These products are intended for use in industrial systems only. Do not
use these products where pressures and temperatures can exceed
those listed under ‘Technical Data’.
Before using these products with fluids other than those specified, for
non-industrial applications, life-support systems, or other applications
not within published specifications, consult Norgren.
Through misuse, age, or malfunction, components used in fluid power
RLF01A-SAB-AA00，英国NORGREN气缸型号
systems can fail in various modes. The system designer is warned to
consider the failure modes of all component parts used in
fluid power systems and to provide adequate safeguards to prevent
personal injury or damage to equipment in the event of such a failure.
System designers must provide a warning to end users in the
system instruction manual if protection against a failure mode
cannot be adequay provided.
System designers and end users are cautioned to review specific
warnings found in instruction sheets packed and shipped with these
products where applicable.
遵守正确的极性（正极到负极）的。
标注规范淬火二极管：
额定电压二极管：UD≥1.4×紫外线
选择个快速开关二极管（恢复时间trr<[200] MS）的。
额定电流二极管：IR≥I负荷
2，并联RC回路并联向负载开关触点。
适用于直流ABD交流电压。
R输入Ω≈0.2×RLOADΩ中
下在μF≈I负荷在
性转换的参考编号：30/min。参考温度：+30°C
星火与二极管DC和感性负载淬火：
爬电距离和空气路径根据对应到B组的缘